设备面板厂家

NewsNews

Contact us

Tel.: + 86 755 8969 9951

Fax: + 86 755 8969 9290

Website: www.jpcelerectronic.com

Address: No.49, Xinhe Road, shangmugu village, Pinghu street, Longgang District, Shenzhen

Your current location: Home >> News >> Technical knowledge

What are the maintenance methods of acrylic panel?

2019-08-26
times

1. Prevent sharp and hard objects from touching

Acrylic panel is actually a kind of organic plastic. Although the general hardness can be played with hands, if it touches very hard cement, then we can add a hard anti scratch treatment to the acrylic panel to make its hardness reach 3H. If the acrylic panel meets more hard nails and other needles, at the moment, our ability is only to add the hardness of the acrylic panel to 6h. So we try our best to let the acrylic panel principle touch and rub these sharp and hard objects. The surface hardness of acrylic panel is equivalent to that of aluminum. Although the hardness is now very large, it is very easy to cut.

2. Prevent high temperature

The temperature of acrylic panel shall not be higher than 90 degrees in continuous application, because the thermal deformation of general acrylic panel is stable at about 100 degrees, and the thermal deformation of general acrylic panel will be caused at 98 degrees, so the high temperature deformation of acrylic products shall be prevented.


手机镜片厂

3. Pay attention to expansion and contraction

In the maintenance of acrylic panels, we usually encounter characteristics. The length, width and height of acrylic panels will increase, but in winter, they will decrease, and the decrease and increase of the layer degree is very low. However, there will be a kind of thermal expansion and contraction of acrylic panels with a certain expansion coefficient. Therefore, the factory should consider the thermal expansion and contraction coefficient of acrylic panels in the installation process, and There must be a stretch gap in the assembly process. This is the detail that must be paid attention to in the process of assembling acrylic panel.

4. Soft towel + 1% soapy water for decontamination

If acrylic panel is blurred or unclean due to slight scratch or dust absorption caused by static electricity, or there will be a layer of ash on the top of acrylic panel due to other reasons, it is recommended to use 1% soapy water to clean it with soft cloth. In this way, it is not only clean, but also not easy to touch the ash layer again. Besides, it does not need to be washed with water again, which is convenient and clean, and it is not easy to leave hand marks on the acrylic panel.


label

Recently, browse:

Contact

Tel.: + 86 755 8969 9951

Fax: + 86 755 8969 9290

Address: No.49, Xinhe Road, shangmugu village, Pinghu street, Longgang District, Shenzhen

Copyright © Shenzhen high quality Electronic Technology Co., L All rights reserved Record number:粤ICP备19103506号-1 Specializing inMobile lens factory, mobile lens factory, equipment panel factory,Welcome to inquire! Technical support:Xiangyun platform Service support:hx300.cn

111.jpg