设备面板厂家

NewsNews

Contact us

Tel.: + 86 755 8969 9951

Fax: + 86 755 8969 9290

Website: www.jpcelerectronic.com

Address: No.49, Xinhe Road, shangmugu village, Pinghu street, Longgang District, Shenzhen

Your current location: Home >> News >> Technical knowledge

Acrylic lens adhesion skills

2019-08-26
times

1. Butt joint: This is very simple. Just put two acrylic pieces to be connected on the operation platform, and glue the adhesive tape at the bottom after closing, leaving a very small gap for this pair of interfaces, and then inject the adhesive.

2. Surface sticking: surface sticking is a special sticking method. First, wipe the surface to be pasted clean, place it horizontally, and apply proper amount of adhesive on it. Place one side of the other acrylic plate obliquely on the acrylic plate which is coated with adhesive, and then put it down evenly and slowly, and push out the bubbles from one side to complete the bonding. (Note: this adhesive will corrode acrylic, so protective measures should be taken)

3. Inclined surface sticking: the sticking inclined surface must use a 90 degree angle profile to prevent the displacement of the glued surface. The adhesive shall be applied evenly and slowly. The profiling can only be removed after complete curing.


设备面板厂家

4. Facade sticking: facade sticking is the most widely used sticking technology. Firstly, the surface to be stuck shall be wiped clean. It is suggested to use profiling to achieve bonding, so that the adhesive does not shake, which is conducive to improving the quality of bonding. The plexiglass board with a thickness of 3mm can be pasted with fine wires, which can be pasted by capillary action. Before the adhesive solidifies, the wires can be pulled out, or the adhesive tape can be used and then the adhesive can be applied.

Market advantages of acrylic

1. High resistance and light transmittance. This kind of acrylic can be used in many places, such as fan Ru's instrument parts, car lights, optical lenses, transparent pipes, etc.

2. There are many categories. It has different kinds of acrylic, satisfied with the needs of different consumers in the degree of spending, also satisfied with the characteristics of different tasters, and made the characteristic of acrylic more perfect.

3. Advantages of quotation. Acrylic has the high brightness and high brightness that the traditional plastics do not have, and it also has a decisive advantage in the quotation, which makes it impossible for businesses to refuse, so there are acrylic shopping malls in various professions.

4. High brightness and transparency. Acrylic has a good name of "plastic crystal". Compared with the traditional ceramic materials, the brightness and transparency are far higher than the traditional ceramic materials, and the transmittance is as high as 92%.


label

Prev:None

Recently, browse:

Contact

Tel.: + 86 755 8969 9951

Fax: + 86 755 8969 9290

Address: No.49, Xinhe Road, shangmugu village, Pinghu street, Longgang District, Shenzhen

Copyright © Shenzhen high quality Electronic Technology Co., L All rights reserved Record number:粤ICP备19103506号-1 Specializing inMobile lens factory, mobile lens factory, equipment panel factory,Welcome to inquire! Technical support:Xiangyun platform Service support:hx300.cn

111.jpg